Plumbing Correct
Blog

What size combi boiler do I need for my home?

How to match a new combi boiler to your hot water use, your mains supply and your home, without paying for power you won't use.

6 November 2026

By Plumbing Correct

What size combi boiler do I need for my home?

If you're replacing a boiler with a combi, the size you need depends mostly on how much hot water your home uses at once, not on how many bedrooms it has. As a rough guide, a flat or small house with one bathroom usually suits a combi of around 24 to 30kW, and a larger house with a bathroom and an en-suite usually needs around 30 to 35kW. But the right size also depends on your mains water supply, which can limit any combi, however powerful.

This post explains what the numbers on a combi mean, what decides the size, the checks you can make yourself before a survey, and when a combi isn't the right boiler at all. Everything here is safe to do without touching the boiler: never remove its casing or work on the gas supply yourself.

What the kW figure on a combi means

A combi boiler heats water straight from the mains as you run a tap, so there's no hot water cylinder. Its size is given in kilowatts (kW), a measure of how much heat it can produce.

Most combis have two figures. The lower one is the heating output, for your radiators. The higher one is the hot water output, and that's the number in the model name, such as a "30kW combi". The hot water figure matters most, because hot water needs far more heat at once than radiators do.

Hot water flow is what you'll notice

What you feel in the shower is the flow rate: how many litres of hot water come out each minute. Manufacturers usually quote it with the water warmed by 35°C, roughly from cold mains to a comfortable shower. As a rough guide:

  • 24kW: about 10 litres a minute

  • 30kW: about 12 litres a minute

  • 35kW: about 14 litres a minute

A typical mixer shower uses around 8 to 10 litres a minute. So a 24kW combi runs one shower well, but struggles if someone runs the kitchen tap at the same time. A bigger combi gives more headroom, though even a large one can't really run two showers at once.

Why your mains water supply matters

A combi can only heat the water your mains pipe gives it. If your supply only delivers 9 litres a minute, a 35kW combi will still only give you 9 litres a minute, and the extra power is wasted.

This catches out many older homes, where the water supply pipe can be narrow, shared or old lead pipe, which water companies say is common in homes built before about 1970. You can check your own flow safely:

  1. Turn on the kitchen cold tap fully.

  2. Time how long it takes to fill a 10-litre bucket.

  3. Divide 600 by the number of seconds. Ten litres in 50 seconds is 12 litres a minute.

Write the figure down and give it to whoever surveys your home. Low flow doesn't rule out a combi, but it changes which one makes sense.

Your gas pipe and your radiators

A bigger combi burns more gas at full power, so the gas pipe from your meter to the boiler has to be big enough to feed it. In many homes the old pipe was sized for a smaller boiler, and it needs upgrading as part of the job. This is checked at the survey and is always work for a Gas Safe registered engineer. Our gas services and pipework page covers this.

Radiators rarely decide the size. Even a large house usually needs less heat for its radiators than a combi produces for hot water. What matters more is the condition of the system: sludge in old pipes and radiators can damage a new boiler, so it's cleaned when the new one goes in, and a badly blocked system may need power flushing first.

Why bigger isn't always better

It's tempting to pick the biggest combi to be safe, but oversizing has costs:

  • A higher price for a boiler whose extra power your mains supply may never use.

  • More stopping and starting. A boiler that's too big for your radiators reaches temperature quickly, switches off, then fires again. This "short cycling" wastes gas and wears parts.

  • Lower efficiency. Modern condensing boilers work best running steadily at lower temperatures, which an oversized boiler finds harder.

The aim is a boiler sized for your real hot water use and supply, with sensible headroom, not the biggest one available.

When a combi isn't the right choice

A combi suits most flats and many houses with one bathroom. It may not suit you if:

  • two bathrooms are often in use at the same time

  • your mains flow is low and can't be improved

  • you have a large family and long morning queues for the shower

In those homes, a system boiler with a hot water cylinder usually works better, because the cylinder stores hot water ready to use in several places at once. An unvented cylinder, which runs at mains pressure, gives strong showers without a tank in the loft.

How we size a new boiler

When we survey your home for a new boiler, a Gas Safe registered engineer looks at your hot water use, your mains flow, the gas pipe, your pipework and where the boiler and flue can go. We then recommend the boiler type and size that suits your home, with a clear, itemised quote. We fit Worcester Bosch, Vaillant and Baxi boilers, and we're Vaillant and Baxi approved.

If you're thinking of replacing your boiler, Plumbing Correct can survey your home in West London and recommend the right size. You can book through our boiler installation service.